Hi, I have looked over these forms and have tried everything recommended yet still can’t get a correct export location and scale. I am trying to export a .xyz dense point cloud to be imported into AutoDesk ReCap. I have set ground control points with an rtk device in coordinate system AZ-CIF. In Reality Capture I have set Project coordinate system and Output coordinate system also to AZ-CIF(afterwards aligning the images).Control points are also set with low error in RC. On export I have set the coordinate system to “Project output”. Even after this my point cloud coordinates are still a few thousand feet away from the actual ground control point locations and it is scaled to about 1/12 of what the actual size is as well. I figure I am missing a few more steps but I am out of ideas on what they could. Can anyone point me in the right direction of what I might be missing?
3 posts - 1 participant